Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- Connected Console Cable and booted up:
- U-Boot 1.1.4 (Apr 24 2013 - 09:58:53)
- Subversion r1.8
- U-boot DB120
- DRAM:
- sri
- Wasp 1.2
- wasp_ddr_initial_config(255): (32bit) ddr2 init
- Setting 0xb8116290 to 0x38702d0f
- 128 MB
- cpu_pll_cfg: 0x21354
- cpu_pll_dither: 0x3c153f
- CFG_PLL_FREQ: 0x1f
- CFG_HZ : 266500000
- CPU Clock: 533MHz DDR Clock: 400MHz
- Top of RAM usable for U-Boot at: 88000000
- Reserving 231k for U-Boot at: 87fc4000
- Reserving 192k for malloc() at: 87f94000
- Reserving 44 Bytes for Board Info at: 87f93fd4
- Reserving 44 Bytes for Global Data at: 87f93fa8
- Reserving 128k for boot params() at: 87f73fa8
- Stack Pointer at: 87f73f88
- Now running in RAM - U-Boot at: 87fc4000
- manufacturerId 0xc2, deviceId0 0x20, deviceId1 0x18
- flash size 16MB, sector count = 256
- flash-2 size 16MB, sector count = 256
- Flash: 16 MB
- pci_init_board: PCIe PLL not set for 40MHz refclk
- BOARD IS NOT CALIBRATED!!!
- pci_init_board: PCI DeviceID=33
- [eapsw_watchdog::status] cold start
- [eapsw_watchdog::status] boot normally
- [eapsw_watchdog::status] autoswitch enabled=On , times=None
- Current Image was A
- In: serial
- Out: serial
- Err: serial
- Net: ag934x_enet_initialize...
- No valid address in Flash. Using fixed address
- wasp reset mask:10c03300
- WASP ----> F1 PHY *
- : cfg1 0x80000000 cfg2 0x7114
- eth0: 00:03:7f:09:0b:ad
- F1Phy reg init
- ATHR_AUTONEG_ADVERT:1DE1
- ATHR_1000BASET_CONTROL:200
- ATHR_PHY_CONTROL:3100
- ATHRSF1_PHY: Port 5, Neg Success
- ATHRSF1_PHY: unit 0 phy addr 5 eth0 up
- eth0
- Hit any key to stop autoboot: 4 3 2 1 0
- ## Booting image at 9fd50000 ...
- Image Name: Linux Kernel Image
- Created: 2014-10-14 3:25:40 UTC
- Image Type: MIPS Linux Kernel Image (lzma compressed)
- Data Size: 927620 Bytes = 905.9 kB
- Load Address: 80002000
- Entry Point: 801edab0
- Verifying Checksum at 0x81000040 ...OK
- Uncompressing Kernel Image ... OK
- No initrd
- ## Transferring control to Linux (at address 801edab0) ...
- ## Giving linux memsize in bytes, 134217728
- Starting kernel ...
- Linux version 2.6.31--LSDK-9.2.0_U10.1020 (sam@samnb-ubnt10) (gcc version 4.3.3 (GCC) ) #1 Tue Apr 1 03:13:16 CST 2014
- flash_size passed from bootloader = 16
- arg 1: console=ttyS0,115200
- arg 2: root=31:2
- arg 3: rootfstype=jffs2
- arg 4: init=/sbin/init
- arg 5: mtdparts=ath-nor0:256k(u-boot),64k(u-env),13M(rootfsA),1536k(knlA),64k(bData),64k(bIndi),1M(apconf),64k(ART);ath-nor1:512k(rA),13M(rootfsB),1536k(knlB),960k(rB),64k(ARTB)
- arg 6: mem=128M
- CPU revision is: 0001974c (MIPS 74Kc)
- ath_sys_frequency: cpu apb ddr apb cpu 532 ddr 400 ahb 200
- Determined physical RAM map:
- memory: 02000000 @ 00000000 (usable)
- User-defined physical RAM map:
- memory: 08000000 @ 00000000 (usable)
- Initrd not found or empty - disabling initrd
- Zone PFN ranges:
- Normal 0x00000000 -> 0x00008000
- Movable zone start PFN for each node
- early_node_map[1] active PFN ranges
- 0: 0x00000000 -> 0x00008000
- Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32512
- Kernel command line: console=ttyS0,115200 root=31:2 rootfstype=jffs2 init=/sbin/init mtdparts=ath-nor0:256k(u-boot),64k(u-env),13M(rootfsA),1536k(knlA),64k(bData),64k(bIndi),1M(apconf),64k(ART);ath-nor1:512k(rA),13M(rootfsB),1536k(knlB),960k(rB),64k(ARTB) mem=128M
- PID hash table entries: 512 (order: 9, 2048 bytes)
- Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
- Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
- Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
- Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
- Writing ErrCtl register=00000000
- Readback ErrCtl register=00000000
- Memory: 112696k/131072k available (1983k kernel code, 18196k reserved, 477k data, 152k init, 0k highmem)
- NR_IRQS:128
- plat_time_init: plat time init done
- Calibrating delay loop... 265.21 BogoMIPS (lpj=530432)
- Mount-cache hash table entries: 512
- ****************ALLOC***********************
- Packet mem: 802a23e0 (0xe00000 bytes)
- ********************************************
- NET: Registered protocol family 16
- PCI init:ath_pcibios_init
- ath_pcibios_init(294): PCI CMD write: 0x356
- registering PCI controller with io_map_base unset
- bio: create slab <bio-0> at 0
- pci 0000:00:00.0: PME# supported from D0 D1 D3hot
- pci 0000:00:00.0: PME# disabled
- Returning IRQ 64
- NET: Registered protocol family 2
- IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
- TCP established hash table entries: 4096 (order: 3, 32768 bytes)
- TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
- TCP: Hash tables configured (established 4096 bind 4096)
- TCP reno registered
- NET: Registered protocol family 1
- ATH GPIOC major 0
- JFFS2 version 2.2 (ZLIB) (RTIME) (c) 2001-2006 Red Hat, Inc.
- msgmni has been set to 220
- io scheduler noop registered
- io scheduler deadline registered (default)
- Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
- serial8250.0: ttyS0 at MMIO 0xb8020000 (irq = 19) is a 16550A
- console [ttyS0] enabled
- brd: module loaded
- 8 cmdlinepart partitions found on MTD device ath-nor0
- Creating 8 MTD partitions on "ath-nor0":
- 0x000000000000-0x000000040000 : "u-boot"
- 0x000000040000-0x000000050000 : "u-env"
- 0x000000050000-0x000000d50000 : "rootfsA"
- 0x000000d50000-0x000000ed0000 : "knlA"
- 0x000000ed0000-0x000000ee0000 : "bData"
- 0x000000ee0000-0x000000ef0000 : "bIndi"
- 0x000000ef0000-0x000000ff0000 : "apconf"
- 0x000000ff0000-0x000001000000 : "ART"
- 5 cmdlinepart partitions found on MTD device ath-nor1
- Creating 5 MTD partitions on "ath-nor1":
- 0x000001000000-0x000001080000 : "rA"
- 0x000000080000-0x000000d80000 : "rootfsB"
- 0x000000d80000-0x000000f00000 : "knlB"
- 0x000000f00000-0x000000ff0000 : "rB"
- 0x000000ff0000-0x000001000000 : "ARTB"
- GACT probability on
- Mirror/redirect action on
- Simple TC action Loaded
- u32 classifier
- Performance counters on
- input device check on
- Actions configured
- TCP cubic registered
- NET: Registered protocol family 10
- IPv6 over IPv4 tunneling driver
- NET: Registered protocol family 17
- Bridge firewalling registered
- arch/mips/atheros/gpio.c (ath_simple_config_init) JUMPSTART_GPIO: 16
- SC Callback Registration for EAPSW_ResetBtn
- athwdt_init: Registering WDT success
- ath_otp_init: Registering OTP success
- ath_clksw_init: Registering Clock Switch Interface success
- VFS: Mounted root (jffs2 filesystem) readonly on device 31:2.
- Freeing unused kernel memory: 152k freed
- init started: BusyBox v1.14.2 (2014-10-14 11:28:31 CST)
- Wed Jan 1 00:00:00 CST 2014
- athstats
- 80211stats
- wlanconfig
- pktlogconf
- pktlogdump
- radartool
- **** drop_caches_sysctl_handler: all done timer added ...****
- Reading image A version ...
- 1.0.0.27
- Reading image B version ...
- 1.0.0.27
- radio_num = 2 not change
- udhcpc (v1.14.2) started
- Sending discover...
- Sending discover...
- Sending discover...
- Sending discover...
- Usage: /etc/udhcpc.script {bound|renew|deconfig}
- No lease, forking to background
- Configuration file: /tmp/secath4
- ath4: Could not connect to kernel driver
- Using interface ath4 with hwaddr 00:c0:ca:8b:dd:04 and ssid "Alfa_AP"
- ath4: interface state UNINITIALIZED->ENABLED
- ath4: AP-ENABLED
- Configuration file: /tmp/secath20
- ath20: Could not connect to kernel driver
- Using interface ath20 with hwaddr 00:c0:ca:8b:dd:14 and ssid "Alfa5G_AP"
- ath20: interface state UNINITIALIZED->ENABLED
- ath20: AP-ENABLED
- ifconfig: br1: error fetching interface information: Device not found
- bind: Address already in use
- bind: Address already in use
- Jan 1 00:01:16 snmpd[1439]: iquerySecName has not been configured - internal queries will fail
- Jan 1 00:01:18 snmpd[1439]: NET-SNMP version 5.4.4
- (none) mips #1 Tue Apr 1 03:13:16 CST 2014 (none)
- (none) login:
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement