CPU0:  P2020E, Version: 2.0, (0x80ea0020)
Core:  E500, Version: 5.0, (0x80211050)
Clock Configuration:
       CPU0:1200 MHz, CPU1:1200 MHz,
       CCB:600  MHz,
       DDR:330  MHz (660 MT/s data rate) (Asynchronous), LBC:37.500 MHz
L1:    D-cache 32 kB enabled
       I-cache 32 kB enabled
Board: S4810 Force10 Networks
Cpld: S4810 cpld Rev 5
Cpld: Board Revision 2
I2C:   ready
DRAM:  Initializing....    DDR:  2 GB (DDR3, 64-bit, CL=6, ECC off)
FLASH: 128 MB
L2:    512 KB enabled
MMC:  FSL_ESDHC: 0
CPLD: HW Watchdog enabled
    eTSEC2 is in sgmii mode.
    eTSEC3 is in sgmii mode.

    PCIE1 used as Root Complex (base addr e000a000)
               Scanning PCI bus 01
        01  00  14e4  b845  0200  00
    PCIE1 on bus 00 - 01



=> printenv
bootdelay=5
baudrate=9600
loads_echo=1
eth1addr=00:E0:0C:02:01:FD
eth2addr=00:E0:0C:02:02:FD
eth3addr=00:E0:0C:02:03:FD
preboot=mii write 0x1 0x1c 0xfcad;mii write 0x1 0x00 0x0140;mii write 0x1 0x1c 0xfcac;mii write 0x1 0x1c 0xb4ef;
rootpath=/opt/nfsroot
hostname=unknown
loadaddr=6400000
uboot=u-boot.bin
uboot_filesize=0x80000
tftpflash=tftpboot $loadaddr $uboot; protect off 0xfff80000 +$uboot_filesize; erase 0xfff80000 +$uboot_filesize; cp.b $loadaddr 0xfff80000 $uboot_filesize; protect on 0xfff80000 +$uboot_filesize; cmp.b $loadaddr 0xfff80000 $uboot_filesize
ethact=eTSEC3
ethaddr=00:01:E8:8A:E8:40
primary_boot=f10boot flash0
secondary_boot=f10boot flash1
default_boot=f10boot flash0
gatewayip=0.0.0.0
mgmtautoneg=true
mgmtspeed100=true
mgmtfullduplex=true
stdin=serial
stdout=serial
stderr=serial
bootcmd=echo Booting primary bootline....;$primary_boot;boot;echo Failed;echo Booting secondary bootline....;$secondary_boot;boot;echo Failed;echo Booting default bootline....;$default_boot;boot;echo Failed;echo Rebooting...;reset