Rockwell TU00-D205-015

====== Rockwell Microtracker TU00-D205-015 GPS Module ======

Pin 1: Antenna power input. Normally 3-5 volts. Maximum 12v, 100mA.
Pin 2: GPS unit power input. 5.0 volts DC. Draws approximately 175mA.
Pin 4: NMEA/Binary mode select. +5v for NMEA. Ov or floating for binary mode.
Pin 5: Battery backup for RTC only (internal clock). 2.5-5 volts.
Pin 6: Serial Data Out. Output of GPS messages. 0/5v level RS-232 signal.
Pin 7: Time Mark Out. IHz (1PPS) timing output.
Pin 8: CTS/DTR Serial Data control. Ov or floating for normal. 5v stops serial output.
Pin 9: Serial Data In. Commands or data sent into GPS here. 0/5v level RS-232.
Pin 10: Battery backup for Sram and RTC. 2.5-5 volts.
Pin 13: Master Reset. +5v to turn on GPS. Ov or floating to turn off and reset.
Pin 18: Serial Data In from DGPS correction receiver. 0/5v level RS-232
Pin 20: Baud Rate select. Ov for 4800 baud. 5v or floating for 9600 baud.
Pins 3, 11, 14, 17, 19 all Grounded
Pins 12, 15, 16 No Connection


Baud rate 4800N1