DDR Version 1.04 20130830
In
DDR3
300MHz
Bus Width=32 Col=10 Bank=8 Row=15 CS=1 Die Bus-Width=16 Size=1024MB
Memory OK
OUT


U-Boot 2014.01-g89b5cf5 (Dec 30 2014 - 13:39:38)

ChipVer: 310B20130131V101
CPU:    RK3188+
Board:  RK30xx platform Board
total reserving memory(except stack) is :48m
DDR Version 1.04 20130830
In
DDR3
300MHz
Bus Width=32 Col=10 Bank=8 Row=15 CS=1 Die Bus-Width=16 Size=1024MB
Memory OK
OUT


U-Boot 2014.01-g89b5cf5 (Dec 30 2014 - 13:39:38)

ChipVer: 310B20130131V101
CPU:    RK3188+
Board:  RK30xx platform Board
total reserving memory(except stack) is :48m
DRAM:  1 GiB
arch_interrupt_init
DMAInit: OK
SdmmcInit=0 0
FwPartOffset=2000 , 0
storage init OK!
Using default environment

In:    serial
Out:   serial
Err:   serial
board_late_init
unsigned!
SecureBootEn = 0 0
##################################################
uboot version: U-Boot 2014.01-g89b5cf5 (Dec 30 2014 - 13:39:38)

#Boot ver: 0000-00-00#0.00

##################################################
setup gpio int
GetParam
check parameter success
partition(boot): offset=0x00002000, size=0x00002000
empty serial no.
Writing env to storage...
done
checkKey
vbus = 1
lcd_ctrl_init [38]
i2c init OVER in board!
set_lcdc_dclk: lcdc_source_clk = 768, clk = 71, div = 11
rk30_load_screen for lcdc ok!
lcd_enable [55]
In charging!
SecureBootCheckOK:0
booti: do_bootm_linux...

Starting kernel ...

Uncompressing Linux... done, booting the kernel.
Booting Linux on physical CPU 0x0
Initializing cgroup subsys cpu
Linux version 3.19.0-rc7+ (paowz@laptop) (gcc version 4.9.2 20140904 (prerelease) (crosstool-NG linaro-1.13.1-4.9-2014.09 - Linaro GCC 4.9-2014.09) ) #1 SMP Mon Feb 9 11:30:21 CET 2015
CPU: ARMv7 Processor [413fc090] revision 0 (ARMv7), cr=10c5387d
CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache
Machine model: Radxa Rock
bootconsole [earlycon0] enabled
Memory policy: Data cache writealloc
On node 0 totalpages: 520192
free_area_init_node: node 0, pgdat c0821840, node_mem_map ee818000
  Normal zone: 1520 pages used for memmap
  Normal zone: 0 pages reserved
  Normal zone: 194560 pages, LIFO batch:31
  HighMem zone: 325632 pages, LIFO batch:31
PERCPU: Embedded 9 pages/cpu @ee7d9000 s7808 r8192 d20864 u36864
pcpu-alloc: s7808 r8192 d20864 u36864 alloc=9*4096
pcpu-alloc: [0] 0 [0] 1 [0] 2 [0] 3
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 518672
Kernel command line: console=tty0 console=ttyS2,115200 debug earlyprintk root=/dev/mmcblk0p1 rootwait rootfstype=ext4 rw splash
PID hash table entries: 4096 (order: 2, 16384 bytes)
Dentry cache hash table entries: 131072 (order: 7, 524288 bytes)
Inode-cache hash table entries: 65536 (order: 6, 262144 bytes)
Memory: 2054712K/2080768K available (5839K kernel code, 346K rwdata, 1880K rodata, 296K init, 339K bss, 26056K reserved, 0K cma-reserved, 1302528K highmem)
Virtual kernel memory layout:
    vector  : 0xffff0000 - 0xffff1000   (   4 kB)
    fixmap  : 0xffc00000 - 0xfff00000   (3072 kB)
    vmalloc : 0xf0000000 - 0xff000000   ( 240 MB)
    lowmem  : 0xc0000000 - 0xef800000   ( 760 MB)
    pkmap   : 0xbfe00000 - 0xc0000000   (   2 MB)
    modules : 0xbf000000 - 0xbfe00000   (  14 MB)
      .text : 0xc0008000 - 0xc0791f9c   (7720 kB)
      .init : 0xc0792000 - 0xc07dc000   ( 296 kB)
      .data : 0xc07dc000 - 0xc0832900   ( 347 kB)
       .bss : 0xc0832900 - 0xc0887780   ( 340 kB)
Hierarchical RCU implementation.
NR_IRQS:16 nr_irqs:16 16
L2C-310 enabling early BRESP for Cortex-A9
L2C-310 full line of zeros enabled for Cortex-A9
L2C-310 dynamic clock gating enabled, standby mode enabled
L2C-310 cache controller enabled, 16 ways, 512 kB
L2C-310: CACHE_ID 0x4100c0c8, AUX_CTRL 0x46050001
sched_clock: 64 bits at 150MHz, resolution 6ns, wraps every 1832519401472ns
Console: colour dummy device 80x30
console [tty0] enabled
Calibrating delay loop... 1196.85 BogoMIPS (lpj=5984256)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 2048 (order: 1, 8192 bytes)
Mountpoint-cache hash table entries: 2048 (order: 1, 8192 bytes)
Initializing cgroup subsys freezer
CPU: Testing write buffer coherency: ok
CPU0: thread -1, cpu 0, socket 0, mpidr 80000000
rockchip_smp_prepare_cpus: ncores 4
Setting up static identity map for 0x605b9948 - 0x605b99a0
CPU1: thread -1, cpu 1, socket 0, mpidr 80000001
CPU2: thread -1, cpu 2, socket 0, mpidr 80000002
CPU3: thread -1, cpu 3, socket 0, mpidr 80000003
Brought up 4 CPUs
SMP: Total of 4 processors activated (4787.40 BogoMIPS).
CPU: All CPU(s) started in SVC mode.
devtmpfs: initialized
VFP support v0.3: implementor 41 architecture 3 part 30 variant 9 rev 4
pinctrl core: initialized pinctrl subsystem
regulator-dummy: no parameters
NET: Registered protocol family 16
DMA: preallocated 256 KiB pool for atomic coherent allocations
cpuidle: using governor ladder
cpuidle: using governor menu
hw-breakpoint: found 5 (+1 reserved) breakpoint and 1 watchpoint registers.
hw-breakpoint: maximum watchpoint size is 4 bytes.
otg-vbus: 5000 mV
reg-fixed-voltage usb-otg-regulator: otg-vbus supplying 5000000uV
sdmmc-supply: 3300 mV
reg-fixed-voltage sdmmc-regulator: Looking up vin-supply from device tree
reg-fixed-voltage sdmmc-regulator: Failed to find supply vin
reg-fixed-voltage sdmmc-regulator: Failed to register regulator: -517
platform sdmmc-regulator: Driver reg-fixed-voltage requests probe deferral
host-pwr: 5000 mV
reg-fixed-voltage usb-host-regulator: host-pwr supplying 5000000uV
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
Linux video capture interface: v2.00
NET: Registered protocol family 23
Bluetooth: Core ver 2.20
NET: Registered protocol family 31
Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
Bluetooth: L2CAP socket layer initialized
Bluetooth: SCO socket layer initialized
cfg80211: Calling CRDA to update world regulatory domain
Switched to clocksource arm_global_timer
simple-framebuffer df000000.framebuffer: framebuffer at 0xdf000000, 0x384000 bytes, mapped to 0xf0400000
simple-framebuffer df000000.framebuffer: format=x8r8g8b8, mode=1280x720x32, linelength=5120
Console: switching to colour frame buffer device 160x45
simple-framebuffer df000000.framebuffer: fb0: simplefb registered!
NET: Registered protocol family 2
TCP established hash table entries: 8192 (order: 3, 32768 bytes)
TCP bind hash table entries: 8192 (order: 4, 65536 bytes)
TCP: Hash tables configured (established 8192 bind 8192)
TCP: reno registered
UDP hash table entries: 512 (order: 2, 16384 bytes)
UDP-Lite hash table entries: 512 (order: 2, 16384 bytes)