U-Boot 2013.04-dirty (Jul 10 2013 - 14:02:53) I2C: ready DRAM: 512 MiB WARNING: Caches not enabled NAND: No NAND device found!!! 0 MiB MMC: OMAP SD/MMC: 0, OMAP SD/MMC: 1 *** Warning - readenv() failed, using default environment musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4 musb-hdrc: 28/31 max ep, 16384/16384 memory USB Peripheral mode controller at 47401000 using PIO, IRQ 0 musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, HB-ISO Rx, HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4 musb-hdrc: 28/31 max ep, 16384/16384 memory USB Host mode controller at 47401800 using PIO, IRQ 0 Net: not set. Validating first E-fuse MAC cpsw, usb_ether Hit any key to stop autoboot: 0 gpio: pin 53 (gpio 53) value is 1 mmc0 is current device micro SD card found mmc0 is current device gpio: pin 54 (gpio 54) value is 1 SD/MMC found on device 0 reading uEnv.txt 252 bytes read in 5 ms (48.8 KiB/s) Loaded environment from uEnv.txt Importing environment from mmc ... Running uenvcmd ... reading uImage-beaglebone.bin 4402240 bytes read in 531 ms (7.9 MiB) ## Booting kernel from Legacy Image a Image Name: Linux-3.8.13 Image Type: ARM Linux Kernel Image Data Size: 4402176 Bytes = 4.2 Load Address: 80008000 Entry Point: 80008000 Verifying Checksum ... OK Loading Kernel Image ... OK OK Starting kernel ... Uncompressing Linux... done, booting the kernel. Error: unrecognized/unsupported machine ID (r1 = 0x00000e05). Available machine support: ID (hex) NAME ffffffff Generic OMAP4 (Flattened Device Tree) ffffffff Generic AM33XX (Flattened Device Tree) ffffffff Generic OMAP3-GP (Flattened Device Tree) ffffffff Generic OMAP3 (Flattened Device Tree) 0000060a OMAP3 Beagle Board 00000a9d IGEP OMAP3 module 00000928 IGEP v2 board 00000ae7 OMAP4 Panda board Please check your kernel config and/or bootloader.