// transmitter.pde
//
// Simple example of how to use VirtualWire to transmit messages
// Implements a simplex (one-way) transmitter with an TX-C1 module
//
// See VirtualWire.h for detailed API docs
// Author: Mike McCauley (mikem@airspayce.com)
// Copyright (C) 2008 Mike McCauley
// $Id: transmitter.pde,v 1.3 2009/03/30 00:07:24 mikem Exp $
#include <VirtualWire.h>
void setup() {
  Serial.begin(9600);   // Debugging only
  Serial.println("setup");
  // Initialise the IO and ISR
  vw_set_tx_pin(8);
  //vw_set_ptt_inverted(true); // Required for DR3100
  vw_setup(2000);      // Bits per sec
}
void loop() {
  const char *msg = "hello";
  digitalWrite(13, true); // Flash a light to show transmitting
  vw_send((uint8_t *)msg, strlen(msg));
  vw_wait_tx(); // Wait until the whole message is gone
  digitalWrite(13, false);
  delay(200);
}

##############FILE SEPARATOR##############

// receiver.pde
//
// Simple example of how to use VirtualWire to receive messages
// Implements a simplex (one-way) receiver with an Rx-B1 module
//
// See VirtualWire.h for detailed API docs
// Author: Mike McCauley (mikem@airspayce.com)
// Copyright (C) 2008 Mike McCauley
// $Id: receiver.pde,v 1.3 2009/03/30 00:07:24 mikem Exp $
#include <VirtualWire.h>
void setup() {
  Serial.begin(9600); // Debugging only
  Serial.println("setup");
  // Initialise the IO and ISR
  vw_set_rx_pin(8);
  //vw_set_ptt_inverted(true); // Required for DR3100
  vw_setup(2000);      // Bits per sec
  vw_rx_start();       // Start the receiver PLL running
}
void loop() {
  uint8_t buf[VW_MAX_MESSAGE_LEN];
  uint8_t buflen = VW_MAX_MESSAGE_LEN;
  if (vw_get_message(buf, &buflen)) {
    int i;
    digitalWrite(13, true); // Flash a light to show received good message
    // Message with a good checksum received, dump it.
    Serial.print("Got: ");
    for (i = 0; i < buflen; i++) {
      Serial.print(buf[i], HEX);
      Serial.print(" ");
    }
    Serial.println("");
    digitalWrite(13, false);
  }
}

PIN setup: http://imgur.com/XFakPpC