*** DiskCheckup V3.1 Build: 1001 Report *** SysInfo DLL Version: SysInfo v1.0 Build: 1014 Time of export: 21:42:14 22-févr.-2012 Device information: Device ID: 1 Interface: ATA Device Capacity: 114470 MB Serial Number: WD-WMAES1931375 Model Number: WDC WD1200JD-00GBB0 Firmware Revision: 02.05D02 Partitions: E: 114470 MB ATA information: Disk geometry: Cylinders: 14593 Tracks/Cylinder: 255 Sectors/Track: 63 Bytes/Sector: 512 Total disk sectors: 234441648 Logical sector size: 512 Physical sector size: 512 Media rotation rate: N/A Buffer size: 8192 KB ECC size: 74 Bytes Standards compliance: ATA8-ACS Supported: No ATA/ATAPI-7 Supported: No ATA/ATAPI-6 Supported: Yes ATA/ATAPI-5 Supported: Yes ATA/ATAPI-4 Supported: Yes World Wide ID: 0000000000000000 Feature support: SMART supported: Yes SMART enabled: No SMART self-test supported: Yes SMART error log supported: Yes LBA supported: Yes IORDY supported: Yes CFast supported: No DMA supported: Yes Maximum Multiword DMA mode supported: 2 Multiword DMA selected: None Maximum UltraDMA mode supported: 5 UltraDMA selected: 5 Maximum PIO mode supported: 4 SATA Compliance: Yes NCQ priority information supported: No Unload while NCQ commands are outstanding supported: No Phy Event Counters supported: No Receipt of power management requests supported: Yes NCQ feature set supported: No SATA Gen2 Signaling Speed (3.0Gb/s) supported: No SATA Gen1 Signaling Speed (1.5Gb/s) supported: Yes Software Settings Preservation: Not supported In-order data delivery: Not supported Initiating power management: Supported, Enabled DMA Setup auto-activation: Not supported Non-zero buffer offsets: Not supported Trusted Computing supported: No Host Protected Area (HPA) supported: Yes Read look-ahead supported: Yes Read look-ahead enabled: Yes Write cache supported: Yes Write cache enabled: Yes Power management supported: Yes Security mode supported: Yes Security mode enabled: No Device Configuration Overlay (DCO) supported: Yes 48bit Addressing supported: Yes Auto Acoustic Managment (AAM) supported: Yes Auto Acoustic Managment (AAM) enabled: No Power-up in Standby (PUIS) supported: Yes Power-up in Standby (PUIS) enabled: No Advanced Power Management (APM) supported: No CompactFlash Association (CFA) supported: No General Purpose Logging (GPL) supported: No Streaming supported: No Media card pass through supported: No Extended power conditions supported: No Extended status reporting supported: No Write-read-verify supported: No Free-fall control supported: No TRIM command supported: No SCT command transport supported: No NV Cache enabled: No NV Cache Power Management supported: No SMART ATTRIBUTES: ID Description Status Value Worst Threshold Raw Value TEC --------------------------------------------------------------------------------------------------------------------------------------------- 1 Raw Read Error Rate OK 200 200 51 0 N.A. 3 Spin Up Time OK 139 131 21 3566 N.A. 4 Start/Stop Count OK 99 99 40 1823 N.A. 5 Reallocated Sector Count OK 200 200 140 0 N.A. 7 Seek Error Rate OK 200 200 51 0 N.A. 9 Power On Time OK 73 73 0 19905 N.A. 10 Spin Retry Count OK 100 100 51 0 N.A. 11 Calibration Retry Count OK 100 100 51 0 N.A. 12 Power Cycle Count OK 99 99 0 1818 N.A. 194 Temperature OK 100 253 0 50 C N.A. 196 Reallocation Event Count OK 200 200 0 0 N.A. 197 Current Pending Sector Count OK 200 200 0 0 N.A. 198 Uncorrectable Sector Count OK 200 200 0 0 N.A. 199 UltraDMA CRC Error Count OK 200 253 0 0 N.A. 200 Write Error Count OK 200 155 51 0 N.A. SMART HISTORY: Error retrieving history