[ 0.000000] Linux version 2.6.36 (havoc@Avernus) (gcc version 4.4.4 (GCC) ) #1 PREEMPT Mon Oct 25 16:29:26 EEST 2010 [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU revision is: 0ad0024f (Ingenic JZRISC) [ 0.000000] Determined physical RAM map: [ 0.000000] User-defined physical RAM map: [ 0.000000] memory: 02000000 @ 00000000 (usable) [ 0.000000] Zone PFN ranges: [ 0.000000] Normal 0x00000000 -> 0x00002000 [ 0.000000] Movable zone start PFN for each node [ 0.000000] early_node_map[1] active PFN ranges [ 0.000000] 0: 0x00000000 -> 0x00002000 [ 0.000000] On node 0 totalpages: 8192 [ 0.000000] free_area_init_node: node 0, pgdat 8040e730, node_mem_map 81000000 [ 0.000000] Normal zone: 64 pages used for memmap [ 0.000000] Normal zone: 0 pages reserved [ 0.000000] Normal zone: 8128 pages, LIFO batch:0 [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 [ 0.000000] Kernel command line: mem=32M console=tty0 console=ttyS0,57600n8 rootfstype=ext2 root=/dev/mmcblk0p1 rw rootwait [ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes) [ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) [ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) [ 0.000000] Primary instruction cache 16kB, VIPT, 4-way, linesize 32 bytes. [ 0.000000] Primary data cache 16kB, 4-way, VIPT, no aliases, linesize 32 bytes [ 0.000000] Memory: 28000k/32768k available (2962k kernel code, 4768k reserved, 1129k data, 220k init, 0k highmem) [ 0.000000] NR_IRQS:190 [ 0.000000] Console: colour dummy device 80x25 [ 0.000000] console [tty0] enabled [ 0.020000] Calibrating delay loop... 335.05 BogoMIPS (lpj=1675264) [ 0.260000] pid_max: default: 32768 minimum: 301 [ 0.270000] Mount-cache hash table entries: 512 [ 0.290000] NET: Registered protocol family 16 [ 0.310000] JZ4740 GPIO initalized [ 0.320000] Qi Hardware JZ4740 QI LB60 setup [ 0.390000] bio: create slab at 0 [ 0.410000] Advanced Linux Sound Architecture Driver Version 1.0.23. [ 0.420000] Switching to clocksource jz4740-timer [ 0.530000] NET: Registered protocol family 2 [ 0.540000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.550000] TCP established hash table entries: 1024 (order: 1, 8192 bytes) [ 0.560000] TCP bind hash table entries: 1024 (order: 0, 4096 bytes) [ 0.570000] TCP: Hash tables configured (established 1024 bind 1024) [ 0.580000] TCP reno registered [ 0.590000] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.600000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.610000] NET: Registered protocol family 1 [ 0.630000] JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc. [ 0.640000] msgmni has been set to 54 [ 0.660000] io scheduler noop registered [ 0.660000] io scheduler deadline registered (default) [ 0.700000] Console: switching to colour frame buffer device 40x30 [ 0.730000] Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled [ 0.740000] serial8250.0: ttyS0 at MMIO 0x10030000 (irq = 17) is a 16550 [ 0.760000] console [ttyS0] enabled, bootconsole disabled [ 0.770000] serial8250.0: ttyS1 at MMIO 0x10031000 (irq = 16) is a 16550 [ 0.800000] NAND device: Manufacturer ID: 0xec, Chip ID: 0xd5 (Samsung NAND 2GiB 3,3V 8-bit) [ 0.810000] Scanning device for bad blocks [ 1.080000] Creating 3 MTD partitions on "jz4740-nand": [ 1.090000] 0x000000000000-0x000000400000 : "NAND BOOT partition" [ 1.100000] 0x000000400000-0x000000800000 : "NAND KERNEL partition" [ 1.110000] 0x000000800000-0x000080000000 : "NAND ROOTFS partition" [ 1.120000] jz4740-nand jz4740-nand.0: Successfully registered JZ4740 NAND driver [ 1.160000] input: gpio-keys as /devices/platform/gpio-keys/input/input0 [ 1.170000] input: matrix-keypad as /devices/platform/matrix-keypad/input/input1 [ 1.180000] input: pwm-beeper as /devices/platform/pwm-beeper/input/input2 [ 1.190000] jz4740-rtc jz4740-rtc: rtc core: registered jz4740-rtc as rtc0 [ 1.220000] jz4740-mmc jz4740-mmc.0: JZ SD/MMC card driver registered [ 1.240000] No device for DAI jz4740-i2s [ 1.300000] asoc: jz4740 <-> jz4740-i2s mapping ok [ 1.320000] mmc0: host does not support reading read-only switch. assuming write-enable. [ 1.340000] ALSA device list: [ 1.350000] mmc0: new SD card at address 1234 [ 1.360000] #0: QI LB60 (jz4740) [ 1.360000] TCP westwood registered [ 1.370000] mmcblk0: mmc0:1234 SA02G 1.83 GiB [ 1.380000] NET: Registered protocol family 17 [ 1.400000] mmcblk0: p1 p2 [ 1.420000] jz4740-rtc jz4740-rtc: setting system clock to 2010-10-25 16:37:19 UTC (1288024639) [ 1.440000] EXT2-fs (mmcblk0p1): warning: mounting unchecked fs, running e2fsck is recommended [ 1.650000] VFS: Mounted root (ext2 filesystem) on device 179:1. [ 1.670000] Freeing unused kernel memory: 220k freed [ 20.050000] ------------[ cut here ]------------ [ 20.050000] WARNING: at kernel/irq/manage.c:290 enable_irq+0x70/0x110() [ 20.050000] Unbalanced enable for IRQ 185 [ 20.050000] Modules linked in: [ 20.050000] Call Trace: [ 20.050000] [<800190ac>] dump_stack+0x8/0x34 [ 20.050000] [<8003e1a4>] warn_slowpath_common+0x78/0xa4 [ 20.050000] [<8003e258>] warn_slowpath_fmt+0x2c/0x38 [ 20.050000] [<8007b530>] enable_irq+0x70/0x110 [ 20.050000] [<8023290c>] jz_battery_read_voltage+0x20/0x124 [ 20.050000] [<80232b58>] jz_battery_get_property+0x70/0x194 [ 20.050000] [<802323f0>] power_supply_show_property+0x58/0x1f8 [ 20.050000] [<802326b4>] power_supply_uevent+0x124/0x220 [ 20.050000] [<801f2988>] dev_uevent+0xa8/0x168 [ 20.050000] [<801a1eb0>] kobject_uevent_env+0x234/0x508 [ 20.050000] [<80058a58>] process_one_work+0x178/0x4ec [ 20.050000] [<80059204>] worker_thread+0x194/0x5a0 [ 20.050000] [<8005de64>] kthread+0x88/0x90 [ 20.050000] [<800205f4>] kernel_thread_helper+0x10/0x18 [ 20.050000] [ 20.050000] ---[ end trace 64c900d244205bb7 ]--- [ 22.070000] power_supply battery: driver failed to report `voltage_now' property [ 35.200000] power_supply battery: driver failed to report `voltage_now' property