#================================================
# WANPIPE1 Configuration File
#================================================
#
# Date: Wed Dec  6 20:29:03 UTC 2006
#
# Note: This file was generated automatically
#       by /usr/local/sbin/setup-sangoma program.
#
#       If you want to edit this file, it is
#       recommended that you use wancfg program
#       to do so.
#================================================
# Sangoma Technologies Inc.
#================================================

[devices]
wanpipe1 = WAN_AFT_TE1, Comment

[interfaces]
w1g1 = wanpipe1, , TDM_VOICE, Comment

[wanpipe1]
CARD_TYPE 	= AFT
S514CPU 	= A
CommPort 	= PRI
AUTO_PCISLOT 	= NO
PCISLOT 	= 4
PCIBUS  	= 8
FE_MEDIA	= E1
FE_LCODE	= HDB3
FE_FRAME	= NCRC4
FE_LINE		= 1
TE_CLOCK 	= NORMAL
TE_REF_CLOCK    = 0
TE_SIG_MODE     = CAS
TE_HIGHIMPEDANCE	= NO
TE_RX_SLEVEL    = 430
HW_RJ45_PORT_MAP = LINEAR
LBO 		= 120OH
FE_TXTRISTATE	= NO
MTU 		= 1500
UDPPORT		= 9000
TTL		= 255
IGNORE_FRONT_END	= NO
TDMV_SPAN		= 1
TDMV_DCHAN		= 0
TE_AIS_MAINTENANCE = NO         #NO: defualt  YES: Start port in AIS Blue Alarm and keep line down
                                #wanpipemon -i w1g1 -c Ttx_ais_off to disable AIS maintenance mode
								#wanpipemon -i w1g1 -c Ttx_ais_on to enable AIS maintenance mode
TDMV_HW_DTMF		= YES		# YES: receive dtmf events from hardware
TDMV_HW_FAX_DETECT		= YES		# YES: receive fax 1100hz events from hardware
HWEC_OPERATION_MODE     = OCT_NORMAL    # OCT_NORMAL: echo cancelation enabled with nlp (default)
										# OCT_SPEECH: improves software tone detection by disabling NLP (echo possible)
										# OCT_NO_ECHO:disables echo cancelation but allows VQE/tone functions.
HWEC_DTMF_REMOVAL       = NO    # NO: default  YES: remove dtmf out of incoming media (must have hwdtmf enabled)
HWEC_NOISE_REDUCTION    = NO    # NO: default  YES: reduces noise on the line - could break fax
HWEC_ACUSTIC_ECHO       = NO    # NO: default  YES: enables acustic echo cancelation
HWEC_NLP_DISABLE        = NO    # NO: default  YES: guarantees software tone detection (possible echo)
HWEC_TX_AUTO_GAIN       = 0     # 0: disable   -40-0: default tx audio level to be maintained (-20 default)
HWEC_RX_AUTO_GAIN       = 0     # 0: disable   -40-0: default tx audio level to be maintained (-20 default)
HWEC_TX_GAIN            = 0		# 0: disable   -24-24: db values to be applied to tx signal
HWEC_RX_GAIN            = 0		# 0: disable   -24-24: db values to be applied to tx signal

[w1g1]
ACTIVE_CH	= ALL
TDMV_HWEC	= YES
MTU 		= 8