root@OpenWrt:/# dmesg [ 0.000000] Linux version 3.3.8 (nils@t410) (gcc version 4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) #1 Thu Sep 27 15:52:25 CEST 2012 [ 0.000000] gpiochip_add: registered GPIOs 0 to 21 on device: ar2315-gpio [ 0.000000] ar2315-gpio: registered 22 GPIOs [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU revision is: 00019064 (MIPS 4KEc) [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 01000000 @ 00000000 (usable) [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] Zone PFN ranges: [ 0.000000] Normal 0x00000000 -> 0x00001000 [ 0.000000] Movable zone start PFN for each node [ 0.000000] Early memory PFN ranges [ 0.000000] 0: 0x00000000 -> 0x00001000 [ 0.000000] On node 0 totalpages: 4096 [ 0.000000] free_area_init_node: node 0, pgdat 802b3790, node_mem_map 802f1000 [ 0.000000] Normal zone: 32 pages used for memmap [ 0.000000] Normal zone: 0 pages reserved [ 0.000000] Normal zone: 4064 pages, LIFO batch:0 [ 0.000000] pcpu-alloc: s0 r0 d32768 u32768 alloc=1*32768 [ 0.000000] pcpu-alloc: [0] 0 [ 0.000000] Built 1 zonelists in Zone order, mobility grouping off. Total pages: 4064 [ 0.000000] Kernel command line: console=ttyS0,9600 rootfstype=squashfs,jffs2 [ 0.000000] PID hash table entries: 64 (order: -4, 256 bytes) [ 0.000000] Dentry cache hash table entries: 2048 (order: 1, 8192 bytes) [ 0.000000] Inode-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.000000] Primary instruction cache 16kB, VIPT, 4-way, linesize 16 bytes. [ 0.000000] Primary data cache 16kB, 4-way, VIPT, no aliases, linesize 16 bytes [ 0.000000] Memory: 13172k/16384k available (2163k kernel code, 3212k reserved, 344k data, 164k init, 0k highmem) [ 0.000000] NR_IRQS:128 [ 0.000000] console [ttyS0] enabled, bootconsole disabled [ 0.010000] Calibrating delay loop... 183.70 BogoMIPS (lpj=918528) [ 0.100000] pid_max: default: 32768 minimum: 301 [ 0.110000] Mount-cache hash table entries: 512 [ 0.120000] NET: Registered protocol family 16 [ 0.840000] bio: create slab at 0 [ 0.860000] PCI host bridge to bus 0000:00 [ 0.870000] pci_bus 0000:00: root bus resource [mem 0x80800000-0x857f7fff] [ 0.880000] pci_bus 0000:00: root bus resource [io 0x817f8000-0x817ffffe] [ 0.890000] pci 0000:00:00.0: [168c:ff18] type 0 class 0x000200 [ 0.890000] pci 0000:00:00.0: reg 10: [mem 0x00000000-0x0001ffff] [ 0.890000] pci 0000:00:00.0: reg 14: [mem 0x00000000-0x03ffffff] [ 0.890000] pci 0000:00:00.0: reg 18: [mem 0x00000000-0x003fffff] [ 0.890000] pci 0000:00:03.0: [168c:ff18] type 0 class 0x000200 [ 0.890000] pci 0000:00:03.0: reg 10: [mem 0x00000000-0x0001ffff] [ 0.890000] pci 0000:00:03.0: reg 14: [mem 0x00000000-0x03ffffff] [ 0.890000] pci 0000:00:03.0: reg 18: [mem 0x00000000-0x003fffff] [ 0.890000] pci 0000:00:00.0: BAR 1: can't assign mem (size 0x4000000) [ 0.900000] pci 0000:00:03.0: BAR 1: can't assign mem (size 0x4000000) [ 0.910000] pci 0000:00:00.0: BAR 2: assigned [mem 0x80800000-0x80bfffff] [ 0.920000] pci 0000:00:03.0: BAR 2: assigned [mem 0x80c00000-0x80ffffff] [ 0.930000] pci 0000:00:00.0: BAR 0: assigned [mem 0x81000000-0x8101ffff] [ 0.940000] pci 0000:00:03.0: BAR 0: assigned [mem 0x81020000-0x8103ffff] [ 0.950000] Switching to clocksource MIPS [ 0.980000] NET: Registered protocol family 2 [ 1.030000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes) [ 1.120000] TCP established hash table entries: 512 (order: 0, 4096 bytes) [ 1.200000] TCP bind hash table entries: 512 (order: -1, 2048 bytes) [ 1.270000] TCP: Hash tables configured (established 512 bind 512) [ 1.350000] TCP reno registered [ 1.390000] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 1.460000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 1.530000] NET: Registered protocol family 1 [ 1.590000] PCI: CLS 0 bytes, default 16 [ 1.590000] WARNING: broken board data detected [ 1.650000] Fixing up empty mac addresses [ 1.690000] Radio config found at offset 0x10000(0x100) [ 1.760000] Radio MAC is blank; using board-data [ 1.840000] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 1.910000] JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [ 2.030000] msgmni has been set to 25 [ 2.070000] io scheduler noop registered [ 2.120000] io scheduler deadline registered (default) [ 2.180000] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled [ 2.280000] serial8250: ttyS0 at MMIO 0xb1100003 (irq = 37) is a 16550A [ 2.370000] gpiodev: gpio device registered with major 254 [ 2.450000] Searching for RedBoot partition table in spiflash at offset 0x3d0000 [ 2.630000] Searching for RedBoot partition table in spiflash at offset 0x3e0000 [ 2.820000] 6 RedBoot partitions found on MTD device spiflash [ 2.890000] Creating 6 MTD partitions on "spiflash": [ 2.950000] 0x000000000000-0x000000010000 : "RedBoot" [ 3.020000] 0x000000010000-0x0000000f0000 : "vmlinux.bin.l7" [ 3.100000] 0x0000000f0000-0x0000003e0000 : "rootfs" [ 3.170000] mtd: partition "rootfs" set to be root filesystem [ 3.240000] mtd: partition "rootfs_data" created automatically, ofs=310000, len=D0000 [ 3.330000] 0x000000310000-0x0000003e0000 : "rootfs_data" [ 3.410000] 0x0000003e0000-0x0000003ef000 : "FIS directory" [ 3.480000] 0x0000003ef000-0x0000003f0000 : "RedBoot config" [ 3.560000] 0x0000003f0000-0x000000400000 : "boardconfig" [ 3.710000] eth0: Atheros AR231x: 36:2a:54:ca:fc:b4, irq 4 [ 3.850000] ar231x_eth_mii: probed [ 3.890000] eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=0:0c) [ 3.980000] Registered led device: gpio1 [ 3.980000] Registered led device: gpio2 [ 3.980000] Registered led device: gpio3 [ 3.990000] Registered led device: gpio4 [ 3.990000] Registered led device: gpio6 [ 3.990000] Registered led device: gpio7 [ 3.990000] TCP cubic registered [ 4.030000] NET: Registered protocol family 17 [ 4.090000] 8021q: 802.1Q VLAN Support v1.8 [ 4.160000] VFS: Mounted root (squashfs filesystem) readonly on device 31:2. [ 4.250000] Freeing unused kernel memory: 164k freed [ 5.970000] eth0: Configuring MAC for full duplex [ 19.090000] Compat-drivers backport release: compat-drivers-2012-09-04-2-gddac993 [ 19.180000] Backport based on wireless-testing.git master-2012-09-07 [ 19.260000] compat.git: wireless-testing.git [ 19.750000] cfg80211: Calling CRDA to update world regulatory domain [ 19.830000] cfg80211: World regulatory domain updated: [ 19.890000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 19.990000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 20.080000] cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 20.180000] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 20.270000] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 20.360000] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 21.460000] cfg80211: World regulatory domain updated: [ 21.520000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 21.620000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 21.720000] cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 21.810000] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 21.900000] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 22.000000] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 22.700000] NET: Registered protocol family 10 [ 26.020000] u32 classifier [ 26.060000] Performance counters on [ 26.100000] input device check on [ 26.150000] Actions configured [ 27.030000] tun: Universal TUN/TAP device driver, 1.6 [ 27.090000] tun: (C) 1999-2004 Max Krasnyansky [ 27.350000] ip_tables: (C) 2000-2006 Netfilter Core Team [ 28.010000] nf_conntrack version 0.5.0 (208 buckets, 832 max) [ 28.850000] ip6_tables: (C) 2000-2006 Netfilter Core Team [ 30.000000] batman_adv: B.A.T.M.A.N. advanced 2012.3.0 (compatibility version 14) loaded [ 38.690000] device eth0 entered promiscuous mode [ 38.760000] br-lan: port 1(eth0) entered forwarding state [ 38.820000] br-lan: port 1(eth0) entered forwarding state [ 40.820000] br-lan: port 1(eth0) entered forwarding state root@OpenWrt:/#