============================
Z5 NAND Boot loader        

2005 (c) Samsung Electronics 

SDRAM Size = 16 MB
============================
>> Started at 354583 usec

>> bootmode = 1, sb_nsect = 0
Detected H/W Type #5 MLC CS4 FM REG
Try SLC
[DRIVER] Initializing NAND flash 
- MAX Interleaving Level = 2
- ROW_SHIFT=12, BLK_SHIFT=18
- CS4 devices
gpmi_enable: E3600 Power on : 8 bit, rdy_mask = 0xf
gpmi_nand8_pio_config: address_setup = 1, data_setup = 4, data_hold = 2, busy_timeout = 50000
Current Timing : TAS(1), TDS(4), TDH(2) Timeout(50000)
Device ID for chip 0 is 
 0 : ec
 1 : d3
 2 : 55
 3 : 25
 4 : 58
ID mismatch...
Try MLC
[DRIVER] Initializing NAND flash (MLC NAND)
- Interleaving Level = 2
- ROW_SHIFT=12, BLK_SHIFT=19
- CS4 devices
gpmi_enable: E3600 Power on : 8 bit, rdy_mask = 0xf
gpmi_nand8_pio_config: address_setup = 1, data_setup = 4, data_hold = 2, busy_timeout = 50000
Current Timing : TAS(1), TDS(4), TDH(2) Timeout(50000)
Device ID for chip 0 is 
 0 : ec
 1 : d3
 2 : 55
 3 : 25
 4 : 58
Device ID for chip 1 is 
 0 : 84
 1 : 84
 2 : 84
 3 : 84
 4 : 84
ID mismatch...
FD_Init is successful
internal #chip = 1
cell type = 4 level cell
number of simultaneously programmed pages = 2
support interleave = 1
support cache program = 0
page size = 2KB
block size = 256KB
organization = x8
plane number = 4                                                                        
plane size = 256MB                                                                      
Cell level = 4 (MLC)                                                                    
 5 batterylevel is 104                                                                  
USB detected                                                                            

 Charging for Low Battery!!!
>> Hit any key to exit to command shell
>> bootmode = 1
>> EMIDRAMCTRL : 0x1b00004
>> EMIDRAMTIME : 0x5422254
>> EMIDRAMTIME2 : 0x400
Load Kernel done successfully.
fbcon_setup: No support for fontwidth 8
init started:  BusyBox v1.00 (2006.04.12-02:27+0000) multi-call binary
dosfsck 2.11, 12 Mar 2005, FAT32, LFN
/dev/ufda1: 12 files, 11/3072 clusters
mount /dev/ufda1 is successful
mount /dev/ufdb1 is successful
Start main UI
/mnt/usb/rc.user: 17: Syntax error: "(" unexpected
Z5 login: