.
.
.
[    0.024173] Mount-cache hash table entries: 512
[    0.028338] Performance Events: no PMU driver, software events only.
[    0.036007] CPU: Geode(TM) Integrated Processor by AMD PCS stepping 02
[    0.044278] NET: Registered protocol family 16
[    0.049510] PCI: PCI BIOS revision 2.10 entry at 0xfced9, last bus=0
[    0.052011] PCI: Using configuration type 1 for base access
[    0.065574] bio: create slab <bio-0> at 0
[    0.069057] SCSI subsystem initialized
[    0.072683] usbcore: registered new interface driver usbfs
[    0.076151] usbcore: registered new interface driver hub
[    0.080177] usbcore: registered new device driver usb
[    0.084466] PCI: Probing PCI hardware
[    0.098518] Switching to clocksource tsc
[    0.100090] FS-Cache: Loaded
[    0.103190] CacheFiles: Loaded
[    0.108066] NET: Registered protocol family 2
[    0.112571] IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
[    0.119696] TCP established hash table entries: 8192 (order: 4, 65536 bytes)
[    0.126982] TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
[    0.133589] TCP: Hash tables configured (established 8192 bind 8192)
[    0.139979] TCP reno registered
[    0.143156] UDP hash table entries: 256 (order: 0, 4096 bytes)
[    0.149038] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[    0.155527] NET: Registered protocol family 1
[    0.160905] platform rtc_cmos: registered platform RTC device (no PNP device found)
[    0.169783] microcode: microcode: CPU0: AMD CPU family 0x5 not supported
[    0.176665] microcode: Microcode Update Driver: v2.00 <tigran@aivazian.fsnet.co.uk>, Peter Oruba
[    0.185635] scx200: NatSemi SCx200 Driver
[    0.205944] msgmni has been set to 500
[    0.211404] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 253)
[    0.218848] io scheduler noop registered
[    0.222882] io scheduler cfq registered (default)
[    0.227662] pci 0000:00:0f.0: allocated PCI BAR #1: base 0x6100
[    0.233781] pci 0000:00:0f.0: cs5535-gpio: GPIO support successfully loaded.
[    0.241461] AMD Geode RNG detected
[    0.245070] Hangcheck: starting hangcheck timer 0.9.1 (tick is 180 seconds, margin is 60 seconds).
[    0.254068] Hangcheck: Using getrawmonotonic().
[    0.258641] Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled
¦[    0.520137] serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a NS16550A
[    0.780135] serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a NS16550A
[    0.787284] 0000:00:0c.0: ttyS2 at I/O 0x1c00 (irq = 9) is a 16C950/954
[    0.794289] 0000:00:0c.0: ttyS3 at I/O 0x1c40 (irq = 9) is a 16C950/954
[    0.801137] Couldn't register serial port 0000:00:0c.1: -28
[    0.810497] loop: module loaded
[    0.813698] pci 0000:00:0f.0: allocated PCI BAR #2: base 0x6200
[    0.819665] pci 0000:00:0f.0: cs5535-mfgpt: 8 MFGPT timers available
[    0.828339] scsi0 : pata_amd
[    0.831698] scsi1 : pata_amd
[    0.834981] ata1: PATA max UDMA/100 cmd 0x1f0 ctl 0x3f6 bmdma 0xff00 irq 14
[    0.841987] ata2: PATA max UDMA/100 cmd 0x170 ctl 0x376 bmdma 0xff08 irq 15
[    0.849772] via-rhine.c:v1.10-LK1.4.3 2007-03-06 Written by Donald Becker
[    0.862405] eth0: VIA Rhine III (Management Adapter) at 0xe0000000, 00:0d:b9:1d:99:94, IRQ 10.
[    0.871775] eth0: MII PHY found at address 1, status 0x7869 advertising 05e1 Link c5e1.
[    0.885630] eth1: VIA Rhine III (Management Adapter) at 0xe0040000, 00:0d:b9:1d:99:95, IRQ 11.
[    0.894999] eth1: MII PHY found at address 1, status 0x7849 advertising 05e1 Link 0000.
[    0.908855] eth2: VIA Rhine III (Management Adapter) at 0xe0080000, 00:0d:b9:1d:99:96, IRQ 15.
[    0.918221] eth2: MII PHY found at address 1, status 0x7849 advertising 05e1 Link 0000.
[    0.926441] tun: Universal TUN/TAP device driver, 1.6
[    0.931531] tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com>
[    0.937911] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
[    0.944601] ehci_hcd 0000:00:0f.5: EHCI Host Controller
[    0.949883] ehci_hcd 0000:00:0f.5: new USB bus registered, assigned bus number 1
[    0.980136] ehci_hcd 0000:00:0f.5: irq 12, io mem 0xefffd000
[    0.996062] ehci_hcd 0000:00:0f.5: USB 2.0 started, EHCI 1.00
[    1.001953] usb usb1: New USB device found, idVendor=1d6b, idProduct=0002
[    1.008788] usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1
[    1.016052] usb usb1: Product: EHCI Host Controller
[    1.020962] usb usb1: Manufacturer: Linux 2.6.37 ehci_hcd
[    1.026397] usb usb1: SerialNumber: 0000:00:0f.5
[    1.032066] hub 1-0:1.0: USB hub found
[    1.035837] hub 1-0:1.0: 4 ports detected
[    1.040648] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
[    1.046986] ohci_hcd 0000:00:0f.4: OHCI Host Controller
[    1.052272] ohci_hcd 0000:00:0f.4: new USB bus registered, assigned bus number 2
[    1.059785] ohci_hcd 0000:00:0f.4: irq 12, io mem 0xefffe000
[    1.072380] ata1.00: CFA: CF Card, Ver2.34, max UDMA/100
[    1.077738] ata1.00: 7880544 sectors, multi 0: LBA
[    1.082670] ata1.00: limited to UDMA/33 due to 40-wire cable
[    1.096260] ata1.00: serial number mismatch '6EB10703040700582043' != '6EB1p703040700582043'
[    1.104738] ata1.00: revalidation failed (errno=-19)
[    1.109740] ata1.00: limiting speed to UDMA/33:PIO3
[    1.152342] usb usb2: New USB device found, idVendor=1d6b, idProduct=0001
[    1.159169] usb usb2: New USB device strings: Mfr=3, Product=2, SerialNumber=1
[    1.166428] usb usb2: Product: OHCI Host Controller
[    1.171339] usb usb2: Manufacturer: Linux 2.6.37 ohci_hcd
[    1.176776] usb usb2: SerialNumber: 0000:00:0f.4
[    1.182136] hub 2-0:1.0: USB hub found
[    1.185942] hub 2-0:1.0: 4 ports detected
[    1.190379] Initializing USB Mass Storage driver...
[    1.195528] usbcore: registered new interface driver usb-storage
[    1.201570] USB Mass Storage support registered.
[    1.206436] usbcore: registered new interface driver libusual
[    1.212462] rtc_cmos rtc_cmos: rtc core: registered rtc_cmos as rtc0
[    1.218890] rtc0: alarms up to one day, 114 bytes nvram
[    1.224262] i2c /dev entries driver
[    1.231316] i2c i2c-0: Unsupported chip (man_id=0x01, chip_id=0x11)
[    1.242730] pci 0000:00:0f.0: registered timer 0
[    1.248249] device-mapper: uevent: version 1.0.3
[    1.253428] device-mapper: ioctl: 4.18.0-ioctl (2010-06-29) initialised: dm-devel@redhat.com
[    1.262370] geode-aes: GEODE AES engine enabled.
[    1.267165] pci 0000:00:0f.0: registered timer 1
[    1.271850] cs5535-clockevt: Registering MFGPT timer as a clock event, using IRQ 7
[    1.279721] Netfilter messages via NETLINK v0.30.
[    1.283438] TCP cubic registered
[    1.288239] NET: Registered protocol family 17
[    1.292150] Bridge firewalling registered
[    1.296906] 802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
[    1.300824] All bugs added by David S. Miller <davem@redhat.com>
[    1.310350] sctp: Hash tables configured (established 8192 bind 16384)
[    6.209775] ata1.00: serial number mismatch '6EB10703040700582043' != '6EB1p703040700582043'
[    6.218324] ata1.00: revalidation failed (errno=-19)
[    6.222235] ata1.00: disabled
[    6.226705] VFS: Cannot open root device "sda2" or unknown-block(0,0)
[    6.230294] Please append a correct "root=" boot option; here are the available partitions:
[    6.241612] Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0)
[    6.249974] Pid: 1, comm: swapper Not tainted 2.6.37 #6
[    6.253893] Call Trace:
[    6.257755]  [<c120ccb9>] ? 0xc120ccb9
[    6.261515]  [<c12b4933>] ? 0xc12b4933
[    6.265384]  [<c12b49e9>] ? 0xc12b49e9
[    6.269140]  [<c12b4198>] ? 0xc12b4198
[    6.272979]  [<c12b4b0b>] ? 0xc12b4b0b
[    6.276739]  [<c12b428b>] ? 0xc12b428b
[    6.280608]  [<c1002d96>] ? 0xc1002d96