*** DiskCheckup V3.1 Build: 1001 Report ***
SysInfo DLL Version: SysInfo v1.0 Build: 1014
Time of export: 21:42:14 22-févr.-2012
Device information:
Device ID: 1
Interface: ATA
Device Capacity: 114470 MB
Serial Number: WD-WMAES1931375
Model Number: WDC WD1200JD-00GBB0
Firmware Revision: 02.05D02
Partitions:
E: 114470 MB
ATA information:
Disk geometry:
Cylinders: 14593
Tracks/Cylinder: 255
Sectors/Track: 63
Bytes/Sector: 512
Total disk sectors: 234441648
Logical sector size: 512
Physical sector size: 512
Media rotation rate: N/A
Buffer size: 8192 KB
ECC size: 74 Bytes
Standards compliance:
ATA8-ACS Supported: No
ATA/ATAPI-7 Supported: No
ATA/ATAPI-6 Supported: Yes
ATA/ATAPI-5 Supported: Yes
ATA/ATAPI-4 Supported: Yes
World Wide ID: 0000000000000000
Feature support:
SMART supported: Yes
SMART enabled: No
SMART self-test supported: Yes
SMART error log supported: Yes
LBA supported: Yes
IORDY supported: Yes
CFast supported: No
DMA supported: Yes
Maximum Multiword DMA mode supported: 2
Multiword DMA selected: None
Maximum UltraDMA mode supported: 5
UltraDMA selected: 5
Maximum PIO mode supported: 4
SATA Compliance: Yes
NCQ priority information supported: No
Unload while NCQ commands are outstanding supported: No
Phy Event Counters supported: No
Receipt of power management requests supported: Yes
NCQ feature set supported: No
SATA Gen2 Signaling Speed (3.0Gb/s) supported: No
SATA Gen1 Signaling Speed (1.5Gb/s) supported: Yes
Software Settings Preservation: Not supported
In-order data delivery: Not supported
Initiating power management: Supported, Enabled
DMA Setup auto-activation: Not supported
Non-zero buffer offsets: Not supported
Trusted Computing supported: No
Host Protected Area (HPA) supported: Yes
Read look-ahead supported: Yes
Read look-ahead enabled: Yes
Write cache supported: Yes
Write cache enabled: Yes
Power management supported: Yes
Security mode supported: Yes
Security mode enabled: No
Device Configuration Overlay (DCO) supported: Yes
48bit Addressing supported: Yes
Auto Acoustic Managment (AAM) supported: Yes
Auto Acoustic Managment (AAM) enabled: No
Power-up in Standby (PUIS) supported: Yes
Power-up in Standby (PUIS) enabled: No
Advanced Power Management (APM) supported: No
CompactFlash Association (CFA) supported: No
General Purpose Logging (GPL) supported: No
Streaming supported: No
Media card pass through supported: No
Extended power conditions supported: No
Extended status reporting supported: No
Write-read-verify supported: No
Free-fall control supported: No
TRIM command supported: No
SCT command transport supported: No
NV Cache enabled: No
NV Cache Power Management supported: No
SMART ATTRIBUTES:
ID Description Status Value Worst Threshold Raw Value TEC
---------------------------------------------------------------------------------------------------------------------------------------------
1 Raw Read Error Rate OK 200 200 51 0 N.A.
3 Spin Up Time OK 139 131 21 3566 N.A.
4 Start/Stop Count OK 99 99 40 1823 N.A.
5 Reallocated Sector Count OK 200 200 140 0 N.A.
7 Seek Error Rate OK 200 200 51 0 N.A.
9 Power On Time OK 73 73 0 19905 N.A.
10 Spin Retry Count OK 100 100 51 0 N.A.
11 Calibration Retry Count OK 100 100 51 0 N.A.
12 Power Cycle Count OK 99 99 0 1818 N.A.
194 Temperature OK 100 253 0 50 C N.A.
196 Reallocation Event Count OK 200 200 0 0 N.A.
197 Current Pending Sector Count OK 200 200 0 0 N.A.
198 Uncorrectable Sector Count OK 200 200 0 0 N.A.
199 UltraDMA CRC Error Count OK 200 253 0 0 N.A.
200 Write Error Count OK 200 155 51 0 N.A.
SMART HISTORY:
Error retrieving history