[root@boggieman nanodebian]# usbboot -c "nprog 0 openwrt-xburst-u-boot.bin 0 0 -n"
usbboot - Ingenic XBurst USB Boot Utility
(c) 2009 Ingenic Semiconductor Inc., Qi Hardware Inc., Xiangfu Liu, Marek Lindner
This program is Free Software and comes with ABSOLUTELY NO WARRANTY.
Now checking whether all configure args valid: YES
Current device information:
CPU type is Ingenic XBurst Jz4740
Crystal work at 12MHz, the CCLK up to 252MHz and PMH_CLK up to 84MHz
SDRAM Total size is 32 MB, work in 4 bank and 16 bit mode
Nand page per block 128, Nand page size 4096, ECC offset in OOB 12, bad block offset in OOB 0, bad block page 127, use 1 plane mode
Execute command: nprog 0 openwrt-xburst-u-boot.bin 0 0 -n
Programing No.0 device, flen 444724, start page 0...
CPU data: Boot4740
Erasing No.0 device No.0 flash (start_blk 0 blk_num 1)......
Finish! Return: 80 00 00 00 00 00 00 00 (position 1)
There are marked bad blocks: 0
Size to send 444724, transfer_size 524288
Image type : without oob
It will cause 1 times buffer transfer.
Writing NAND page 0 len 446464...
CPU data: Boot4740
Finish! (len 446464 start_page 0 page_num 109)
Checking 446464 bytes... no check! End at Page: 109
[root@boggieman nanodebian]#