# Customized settings for lirc daemon
# The hardware driver to use, run lircd --driver=? for a list
DRIVER="devinput"
# Hardware driver module to load
HWMOD="lirc_dev nuvoton_cir"
# The device node that communicates with the IR device.
# if you are using lirc_serial, set DEVICE to /dev/ttyS[0-9]
# where 0-9 is the serial port your IR receiver is plugged
# with devfs enabled
#DEVICE=/dev/lirc0
DEVICE=/dev/input/event2
#DEVICE=/dev/lirc/serial
# without devfs
#DEVICE=/dev/lirc
# Serial port for the receiver (for serial driver)
# COM1 (/dev/ttyS0)
#COM_PORT=/dev/ttyS0
#DRIVER_OPTS="irq=4 io=0x3f8"
# COM2 (/dev/ttyS1)
#COM_PORT=/dev/ttyS1
#DRIVER_OPTS="irq=3 io=0x2f8"
# COM3 (/dev/ttyS2)
#COM_PORT=/dev/ttyS2
#DRIVER_OPTS="irq=4 io=0x3e8
# COM4 (/dev/ttyS3)
#COM_PORT=/dev/ttyS3
#DRIVER_OPTS="irq=3 io=0x2e8"