zj1992

pci 0000:00:0c.0: reg 10 io port: [0x1000-0x10ff]
pci 0000:00:0c.0: reg 14 32bit mmio: [0xe8000000-0xe8001fff]
pci 0000:00:0c.0: supports D1 D2
pci 0000:00:0c.0: PME# supported from D1 D2 D3hot
pci 0000:00:0c.0: PME# disabled
pci 0000:00:0d.0: reg 10 32bit mmio: [0xe8002000-0xe80020ff]
pci 0000:00:0d.0: reg 14 io port: [0x1830-0x1837]
pci 0000:00:0d.0: reg 18 io port: [0x1400-0x14ff]
pci 0000:00:0d.0: supports D2
pci 0000:00:0d.0: PME# supported from D2 D3hot D3cold
pci 0000:00:0d.0: PME# disabled
pci 0000:01:01.0: reg 10 32bit mmio: [0xf0000000-0xf7ffffff]
pci 0000:01:01.0: reg 30 32bit mmio pref: [0x000000-0x00ffff]
pci 0000:01:01.0: supports D1 D2
pci 0000:00:01.0: bridge 32bit mmio: [0xf0000000-0xf7ffffff]
--
Maestro3 0000:00:0c.0: PCI INT A -> Link[LNKC] -> GSI 11 (level, low) -> IRQ 11
Maestro3 0000:00:0c.0: firmware: requesting ess/maestro3_assp_kernel.fw
b43-pci-bridge 0000:06:00.0: enabling device (0000 -> 0002)
b43-pci-bridge 0000:06:00.0: PCI INT A -> Link[LNKB] -> GSI 10 (level, low) -> IRQ 10
b43-pci-bridge 0000:06:00.0: setting latency timer to 64
ssb: Sonics Silicon Backplane found on PCI device 0000:06:00.0
Maestro3 0000:00:0c.0: PCI INT A disabled
Maestro3: probe of 0000:00:0c.0 failed with error -2
cfg80211: Calling CRDA to update world regulatory domain
b43legacy-phy0: Broadcom 4306 WLAN found
phy0: Selected rate control algorithm 'minstrel'
Broadcom 43xx-legacy driver loaded [ Features: PLID, Firmware-ID: FW10 ]
udev: renamed network interface wlan0 to wlan1
Adding 151160k swap on /dev/sda5.  Priority:-1 extents:1 across:151160k
EXT3 FS on sda1, internal journal
b43legacy ssb0:0: firmware: requesting b43legacy/ucode4.fw
b43legacy ssb0:0: firmware: requesting b43legacy/pcm4.fw
b43legacy ssb0:0: firmware: requesting b43legacy/b0g0initvals2.fw