Printrbot Metal Plus - Cura Profile - 0.09525mm @ 30mms

Layer Height 0.09525 mm
First Layer Height 0.142875 mm
First Layer Width Factor 125 %
Shell Thickness 0.8 mm
Cut off Object Bottom 0 mm
Solid Top Yes
Solid Bottom Yes
Fill Density 15 %
Bottom/Top Thickness 0.8 mm
Infill prints after perimeters Yes
Print Speed 30 mm/s
Infill Speed 0 mm/s
Top/bottom speed 0 mm/s
Inner Shell Speed 0 mm/s
Outer Shell Speed 0 mm/s
Travel Speed 100 mm/s
Bottom Layer Speed 30 mm/s
Number of Skirt Lines 6
Skirt Gap 10 mm
Skirt Minimal Length 150 mm
Number of Brim Lines 0
Support None
Support Type Lines
Support Angle 60 °
Platform Adhesion None
Raft Margin 5 mm
Raft Line Spacing 3 mm
Raft Base Thickness 0.3 mm
Raft Base Line Width 1 mm
Raft Interface Thickness 0.27 mm
Raft Interface Line Width 0.4 mm
Raft Last Layer Gap 0 mm
Raft First Layer Gap 0.22 mm
Raft Surface Layers 2
Surface layer thickness 0.27 mm
Surface layer line width 0.4 mm
Support Fill Rate 15 %
Support X/Y Distance 0.7 mm
Support Z Distance 0.15 mm
Support For Dual Extrusion Both
Wipe Tower Volume 15 mm3
Overlap Dual 0.15 mm
Filament Diameter 1.75 mm
Filament Flow 95 %
Print Temperature 210 °C
Print Bed Temperature 60 °C
Enable Fan Yes
Minimum Fan Speed 100 %
Maximum Fan Speed 100 %
Fan Full Height 0.1 mm
Minimum Layer Cooling Time 30 secs
Minimum Cooling Feedrate 30 mm/s
Enable Retraction Yes
Retraction Amount 0.75 mm
Retraction Speed 30 mm/2
Retraction Minimal Travel 1.5 mm
Retraction Minimal Extrusion 0.02 mm
Enable Combing Off
Retraction Hop 0.1 mm
Retraction Dual Amount 16.5 mm
Wipe Tower No
Ooze Shield No
Cooling Head Lift No
Spiral Vase No
Only follow mesh surface No
Nozzle Size 0.4 mm