#<TXS>     =  0 (THREAD X_Start)
	#<TZS>     =  0.1 (THREAD Z_Start)
	#<TSD>     =  [1/4] (THREAD SIZE MAJOR DIA IN 0.5555 FORMAT)
	#<Pitch>   =  0 (Pitch IN 0.5555 FORMAT SET TO 0 IF USING TPI MODE)
	#<TPI>     =  20 (THREADS PER INCH SET TO 0 IF USING PITCH MODE)
	#<TIE>     =  2 (EXTURNAL OR INTURNAL THREAD, 1 = INT, 2 = EXT)
	#<TZE>     	= -0.250  (THREAD Z END)
	#<RZS>		= 0.05 ;RESIZE Z START
	#<RZE>     =  [#<TZE>-0.025] (RESIZE Z END)
	#<TUNN>    =  1 (THREADING UN NUMBER, 1 HAS MORE THREAD AND 2 HAS LESS, ONLY USED FOR EXT THREADING)
	#<TFNT>    =  0.000 (THREADING FUDGE NUMBER, USED FOR GETTING JUST THE RIGHT FIT, OR TOOL WEAR OR THREADING TOOL)
	#<TFNR>    =  0.000 (RESIZING FUDGE NUMBER, USED FOR GETTING JUST THE RIGHT FIT, OR TOOL WEAR OR RESIZING TOOL)
	#<TSE>     =  2 (THREADING SUB END TOOL LOCATION, 1 FOR END OF THREAD, 2 FOR BACK TO THE X AND Z STARTING POINT)
	#<TTC>     =  0.01 (THREADING TOOL CLEARANCE, ALWAYS A POSITIVE NUMBER, THE DISTANCE ABOVE THE THREADS FOR Z RETURN)
	#<TFCD>    =  0.01 (FISRT CUT DEPTH)
	#<TDD>     =  1.75 (1.0 = constant depth, 2.0 = constant area any number >= 1.0 allowed)
	#<TNSC>    =  3 (NUMBER OF SPRING CUTS)
	#<TCSA>    =  29.5 (compound_slide_angle)
	#<TDT>     =  0 (distance along drive line used for tapered start/end)
	#<TWE>     =  0 (which ends get the taper: 0 = neither, 1 = begin, 2 = end, 3 = both)

	#<TSOHS>   =  0.3 (USE DIA VALUE STOCK OD SIZE FOR RESIZING EXT OD SIZE OR PREDRILLED HOLE SIZE FOR RESIZING ID SIZE)

	#<TRTN>    =  1 (RESIZING TOOL NUMBER)
	#<TTN>     =  400 (THREADING TOOL NUMBER)
	#<TMRCD>   = 0.02 (MAX DEPTH OF CUT FOR RESIZING)
	#<TRRC>     = 0.007 (RETRACT CLEARENCE FOR RESIZING)
	#<TRFC>		= 0 ;RESIZING FINISH CUT
	#<TRFR> 	= 0.005 ;RESIZING /BROING FEED RATE
	#<TIM>		= 1		;impereal or meteric 1= i and 2= m