Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- If it looks like it needs it, do it!
- 1. With the Zing off, remove the cutting bed (the grid and the box it's attached to)
- 2. Remove the bed's front panel and dump the cutting byproducts in the trash
- 3. With a hex wrench, remove the brackets on either side of the bed. Put the brackets off to the side and be careful to not lose the hex nuts.
- 4. Put on some gloves
- 5. Lift up the grid and put it on the black tray stored by the dividing wall
- 6. Take the tray with grid to the utility sink along with the purple bottle of Zep Industrial Purple Cleaner & Degreaser
- 7. Place the tray on top of the sink. Fill it ⅔ with warm water. Level the tray with a shim if necessary
- 8. Pour ½ cup to 1 cup of solvent into the water
- 9. Gently move the grid around in the solution. It will foam
- 10. Do this for about a minute. Then put the grid into the sink
- 11. Lift one end of the tray and pour the solution down the sink
- 12. Rinse both the tray and the grid with warm water. Using a cup helps
- 13. Let the tray and grid dry.
- 14. Put the grid back into the cutting bed. Be careful to square up the brackets
- 15. Put the tray back by the dividing wall
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement