Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- U-Boot 1.1.3 (Mar 2 2016 - 14:05:04)
- Board: MediaTek APSoC DRAM: 64 MB
- enable ephy clock...done. SSC disabled.
- ******************************
- Software System Reset Occurred
- ******************************
- MediaTek SPI flash driver, SPI clock: 48MHz
- spi device id: ef 40 17 0 0 (40170000)
- find flash: W25Q64BV
- *** Warning - bad CRC, using default environment
- ============================================
- MediaTek U-Boot Version: 5.0.0.5
- --------------------------------------------
- ASIC 7620_MP (Port5<->None)
- DRAM component: 512 Mbits DDR, width 16
- DRAM bus: 16 bit
- Total memory: 64 MBytes
- Flash component: SPI Flash
- Date:Mar 2 2016 Time:14:05:04
- ============================================
- icache: sets:512, ways:4, linesz:32, total:65536
- dcache: sets:256, ways:4, linesz:32, total:32768
- #### The CPU freq = 580 MHZ ####
- estimate memory size = 64 Mbytes
- Please choose the operation:
- 0: Load system code then write to Flash via Serial.
- 1: Load system code to SDRAM via TFTP.
- 2: Load system code then write to Flash via TFTP.
- 3: Boot system code via Flash (default).
- 4: Enter boot command line interface.
- 7: Load U-Boot code then write to Flash via Serial.
- 9: Load U-Boot code then write to Flash via TFTP. 0
- 3: System Boot system code via Flash.
- ## Checking image at bc050000 ...
- Image Name: SNR-CPE-W4N-MT
- Image Type: MIPS Linux Kernel Image (lzma compressed)
- Data Size: 6816485 Bytes = 6.5 MB
- Load Address: 80000000
- Entry Point: 80000000
- Verifying Checksum ... OK
- Uncompressing Kernel Image ... OK
- No initrd
- ## Transferring control to Linux (at address 80000000) ...
- ## Giving linux memsize in MB, 64
- Starting kernel ...
- [ 0.000000] Linux version 5.10.144 (user@debian) (mipsel-openwrt-linux-musl-gcc (OpenWrt GCC 11.3.0 r20779+1-c5e167e0d6) 11.3.0, GNU ld (GNU Binutils) 2.37) #0 Mon Oct 3 16:36:17 2022
- [ 0.000000] Board has DDR1
- [ 0.000000] Analog PMU set to hw control
- [ 0.000000] Digital PMU set to hw control
- [ 0.000000] SoC Type: MediaTek MT7620N ver:2 eco:6
- [ 0.000000] printk: bootconsole [early0] enabled
- [ 0.000000] CPU0 revision is: 00019650 (MIPS 24KEc)
- [ 0.000000] MIPS: machine is SNR-CPE-W4N (rev.M)
- [ 0.000000] Initrd not found or empty - disabling initrd
- [ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
- [ 0.000000] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
- [ 0.000000] Zone ranges:
- [ 0.000000] Normal [mem 0x0000000000000000-0x0000000003ffffff]
- [ 0.000000] Movable zone start for each node
- [ 0.000000] Early memory node ranges
- [ 0.000000] node 0: [mem 0x0000000000000000-0x0000000003ffffff]
- [ 0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000003ffffff]
- [ 0.000000] Built 1 zonelists, mobility grouping on. Total pages: 16240
- [ 0.000000] Kernel command line: console=ttyS0,57600 rootfstype=squashfs,jffs2
- [ 0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes, linear)
- [ 0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes, linear)
- [ 0.000000] Writing ErrCtl register=00076fd0
- [ 0.000000] Readback ErrCtl register=00076fd0
- [ 0.000000] mem auto-init: stack:off, heap alloc:off, heap free:off
- [ 0.000000] Memory: 56424K/65536K available (5253K kernel code, 613K rwdata, 1112K rodata, 1204K init, 209K bss, 9112K reserved, 0K cma-reserved)
- [ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
- [ 0.000000] NR_IRQS: 256
- [ 0.000000] CPU Clock: 580MHz
- [ 0.000000] clocksource: systick: mask: 0xffff max_cycles: 0xffff, max_idle_ns: 583261500 ns
- [ 0.000000] systick: enable autosleep mode
- [ 0.000000] systick: running - mult: 214748, shift: 32
- [ 0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 6590553264 ns
- [ 0.000010] sched_clock: 32 bits at 290MHz, resolution 3ns, wraps every 7405115902ns
- [ 0.015565] Calibrating delay loop... 385.84 BogoMIPS (lpj=1929216)
- [ 0.087807] pid_max: default: 32768 minimum: 301
- [ 0.097188] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
- [ 0.111594] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
- [ 0.129563] dyndbg: Ignore empty _ddebug table in a CONFIG_DYNAMIC_DEBUG_CORE build
- [ 0.148569] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
- [ 0.168055] futex hash table entries: 256 (order: -1, 3072 bytes, linear)
- [ 0.181652] pinctrl core: initialized pinctrl subsystem
- [ 0.193136] NET: Registered protocol family 16
- [ 0.268146] rt2880_gpio 10000600.gpio: registering 24 gpios
- [ 0.279219] rt2880_gpio 10000600.gpio: registering 24 irq handlers
- [ 0.291776] rt2880_gpio 10000638.gpio: registering 16 gpios
- [ 0.302789] rt2880_gpio 10000638.gpio: registering 16 irq handlers
- [ 0.315366] rt2880_gpio 10000688.gpio: registering 1 gpios
- [ 0.326204] rt2880_gpio 10000688.gpio: registering 1 irq handlers
- [ 0.348378] clocksource: Switched to clocksource systick
- [ 0.360233] NET: Registered protocol family 2
- [ 0.369133] IP idents hash table entries: 2048 (order: 2, 16384 bytes, linear)
- [ 0.384230] tcp_listen_portaddr_hash hash table entries: 512 (order: 0, 4096 bytes, linear)
- [ 0.400857] TCP established hash table entries: 1024 (order: 0, 4096 bytes, linear)
- [ 0.415980] TCP bind hash table entries: 1024 (order: 0, 4096 bytes, linear)
- [ 0.429985] TCP: Hash tables configured (established 1024 bind 1024)
- [ 0.442771] UDP hash table entries: 256 (order: 0, 4096 bytes, linear)
- [ 0.455684] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes, linear)
- [ 0.469850] NET: Registered protocol family 1
- [ 0.478441] PCI: CLS 0 bytes, default 32
- [ 0.491648] rt-timer 10000100.timer: maximum frequency is 1220Hz
- [ 0.506707] workingset: timestamp_bits=14 max_order=14 bucket_order=0
- [ 0.524974] squashfs: version 4.0 (2009/01/31) Phillip Lougher
- [ 0.536479] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
- [ 0.559475] Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
- [ 0.573206] printk: console [ttyS0] disabled
- [ 0.581717] 10000c00.uartlite: ttyS0 at MMIO 0x10000c00 (irq = 20, base_baud = 2500000) is a Palmchip BK-3103
- [ 0.601362] printk: console [ttyS0] enabled
- [ 0.601362] printk: console [ttyS0] enabled
- [ 0.617924] printk: bootconsole [early0] disabled
- [ 0.617924] printk: bootconsole [early0] disabled
- [ 0.648153] spi spi0.0: force spi mode3
- [ 0.657324] spi-nor spi0.0: s25fl064k (8192 Kbytes)
- [ 0.667213] 7 fixed-partitions partitions found on MTD device spi0.0
- [ 0.679945] OF: Bad cell count for /palmbus@10000000/spi@b00/flash@0/partitions
- [ 0.694546] OF: Bad cell count for /palmbus@10000000/spi@b00/flash@0/partitions
- [ 0.709691] OF: Bad cell count for /palmbus@10000000/spi@b00/flash@0/partitions
- [ 0.724337] OF: Bad cell count for /palmbus@10000000/spi@b00/flash@0/partitions
- [ 0.739173] Creating 7 MTD partitions on "spi0.0":
- [ 0.748785] 0x000000000000-0x000000030000 : "Bootloader"
- [ 0.762719] 0x000000030000-0x000000040000 : "Config"
- [ 0.773923] 0x000000040000-0x000000140000 : "Factory"
- [ 0.787164] 0x000000050000-0x00000015473a : "Kernel_stub"
- [ 0.798012] mtd: partition "Kernel_stub" doesn't end on an erase/write block -- force read-only
- [ 0.817592] 0x00000015473a-0x00000018473a : "RootFS_stub"
- [ 0.828452] mtd: partition "RootFS_stub" doesn't start on an erase/write block boundary -- force read-only
- [ 0.849972] 0x000000080000-0x000000800000 : "RW-FS"
- [ 0.860993] 0x000000050000-0x000000800000 : "firmware"
- [ 0.906029] gsw: setting port4 to ephy mode
- [ 0.914596] mtk_soc_eth 10100000.ethernet: generated random MAC address 56:61:49:5c:14:21
- [ 0.930922] mtk_soc_eth 10100000.ethernet: no mdio-bus child node found
- [ 0.944119] mtk_soc_eth 10100000.ethernet: mdio-bus disabled
- [ 0.955623] mtk_soc_eth 10100000.ethernet: loaded mt7620 driver
- [ 0.968200] mtk_soc_eth 10100000.ethernet eth0: mediatek frame engine at 0xb0100000, irq 5
- [ 0.985409] rt2880_wdt 10000120.watchdog: Initialized
- [ 0.996833] NET: Registered protocol family 10
- [ 1.011857] Segment Routing with IPv6
- [ 1.019380] NET: Registered protocol family 17
- [ 1.028369] 8021q: 802.1Q VLAN Support v1.8
- [ 1.038965] /dev/root: Can't open blockdev
- [ 1.047144] VFS: Cannot open root device "(null)" or unknown-block(0,0): error -6
- [ 1.062133] Please append a correct "root=" boot option; here are the available partitions:
- [ 1.078793] 1f00 192 mtdblock0
- [ 1.078798] (driver?)
- [ 1.091819] 1f01 64 mtdblock1
- [ 1.091824] (driver?)
- [ 1.104847] 1f02 1024 mtdblock2
- [ 1.104851] (driver?)
- [ 1.117871] 1f03 1041 mtdblock3
- [ 1.117876] (driver?)
- [ 1.130908] 1f04 192 mtdblock4
- [ 1.130913] (driver?)
- [ 1.143934] 1f05 7680 mtdblock5
- [ 1.143938] (driver?)
- [ 1.156960] 1f06 7872 mtdblock6
- [ 1.156964] (driver?)
- [ 1.169997] Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0)
- [ 1.186462] Rebooting in 1 seconds..
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement