Advertisement
Not a member of Pastebin yet?
Sign Up,
it unlocks many cool features!
- Bytes transferred = 5505828 (540324 hex)
- LoadAddr=80100000 NetBootFileXferSize=00540324
- ## Checking image at 80100000 ...
- Image Name: SNR-CPE-W4N-MT
- Image Type: MIPS Linux Kernel Image (uncompressed)
- Data Size: 2181019 Bytes = 2.1 MB
- Load Address: 80000000
- Entry Point: 80000000
- Verifying Checksum ... OK
- Copy 5505828 bytes to Flash...
- ....................................................................................
- ....................................................................................
- .
- .
- Done!
- 5505828 bytes flashed
- ## Checking image at bc050000 ...
- Image Name: SNR-CPE-W4N-MT
- Image Type: MIPS Linux Kernel Image (uncompressed)
- Data Size: 2181019 Bytes = 2.1 MB
- Load Address: 80000000
- Entry Point: 80000000
- Verifying Checksum ... OK
- OK
- No initrd
- ## Transferring control to Linux (at address 80000000) ...
- ## Giving linux memsize in MB, 64
- Starting kernel ...
- OpenWrt kernel loader for MIPS based SoC
- Copyright (C) 2011 Gabor Juhos <juhosg@openwrt.org>
- Decompressing kernel... done!
- Starting kernel at 80000000...
- [ 0.000000] Linux version 5.10.144 (user@debian) (mipsel-openwrt-linux-musl-gcc (OpenWrt GCC 11.3.0 r20779+1-c5e167e0d6) 11.3.0, GNU ld (GNU Binutils) 2.37) #0 Sun Oct 2 01:06:16 2022
- [ 0.000000] Board has DDR1
- [ 0.000000] Analog PMU set to hw control
- [ 0.000000] Digital PMU set to hw control
- [ 0.000000] SoC Type: MediaTek MT7620N ver:2 eco:6
- [ 0.000000] printk: bootconsole [early0] enabled
- [ 0.000000] CPU0 revision is: 00019650 (MIPS 24KEc)
- [ 0.000000] MIPS: machine is SNR-CPE-W4N (rev.M)
- [ 0.000000] Initrd not found or empty - disabling initrd
- [ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
- [ 0.000000] Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
- [ 0.000000] Zone ranges:
- [ 0.000000] Normal [mem 0x0000000000000000-0x0000000003ffffff]
- [ 0.000000] Movable zone start for each node
- [ 0.000000] Early memory node ranges
- [ 0.000000] node 0: [mem 0x0000000000000000-0x0000000003ffffff]
- [ 0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000003ffffff]
- [ 0.000000] Built 1 zonelists, mobility grouping on. Total pages: 16240
- [ 0.000000] Kernel command line: console=ttyS0,57600 rootfstype=squashfs,jffs2
- [ 0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes, linear)
- [ 0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes, linear)
- [ 0.000000] Writing ErrCtl register=000676d0
- [ 0.000000] Readback ErrCtl register=000676d0
- [ 0.000000] mem auto-init: stack:off, heap alloc:off, heap free:off
- [ 0.000000] Memory: 56424K/65536K available (5253K kernel code, 613K rwdata, 1112K rodata, 1204K init, 209K bss, 9112K reserved, 0K cma-reserved)
- [ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
- [ 0.000000] NR_IRQS: 256
- [ 0.000000] CPU Clock: 580MHz
- [ 0.000000] clocksource: systick: mask: 0xffff max_cycles: 0xffff, max_idle_ns: 583261500 ns
- [ 0.000000] systick: enable autosleep mode
- [ 0.000000] systick: running - mult: 214748, shift: 32
- [ 0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 6590553264 ns
- [ 0.000010] sched_clock: 32 bits at 290MHz, resolution 3ns, wraps every 7405115902ns
- [ 0.015564] Calibrating delay loop... 385.84 BogoMIPS (lpj=1929216)
- [ 0.087801] pid_max: default: 32768 minimum: 301
- [ 0.097185] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
- [ 0.111591] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes, linear)
- [ 0.129560] dyndbg: Ignore empty _ddebug table in a CONFIG_DYNAMIC_DEBUG_CORE build
- [ 0.148545] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
- [ 0.168031] futex hash table entries: 256 (order: -1, 3072 bytes, linear)
- [ 0.181617] pinctrl core: initialized pinctrl subsystem
- [ 0.193107] NET: Registered protocol family 16
- [ 0.268461] rt2880_gpio 10000600.gpio: registering 24 gpios
- [ 0.279533] rt2880_gpio 10000600.gpio: registering 24 irq handlers
- [ 0.292089] rt2880_gpio 10000638.gpio: registering 16 gpios
- [ 0.303098] rt2880_gpio 10000638.gpio: registering 16 irq handlers
- [ 0.315683] rt2880_gpio 10000688.gpio: registering 1 gpios
- [ 0.326522] rt2880_gpio 10000688.gpio: registering 1 irq handlers
- [ 0.348750] clocksource: Switched to clocksource systick
- [ 0.360614] NET: Registered protocol family 2
- [ 0.369501] IP idents hash table entries: 2048 (order: 2, 16384 bytes, linear)
- [ 0.384601] tcp_listen_portaddr_hash hash table entries: 512 (order: 0, 4096 bytes, linear)
- [ 0.401228] TCP established hash table entries: 1024 (order: 0, 4096 bytes, linear)
- [ 0.416352] TCP bind hash table entries: 1024 (order: 0, 4096 bytes, linear)
- [ 0.430356] TCP: Hash tables configured (established 1024 bind 1024)
- [ 0.443143] UDP hash table entries: 256 (order: 0, 4096 bytes, linear)
- [ 0.456055] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes, linear)
- [ 0.470223] NET: Registered protocol family 1
- [ 0.478814] PCI: CLS 0 bytes, default 32
- [ 0.491985] rt-timer 10000100.timer: maximum frequency is 1220Hz
- [ 0.507055] workingset: timestamp_bits=14 max_order=14 bucket_order=0
- [ 0.525312] squashfs: version 4.0 (2009/01/31) Phillip Lougher
- [ 0.536817] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
- [ 0.559830] Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
- [ 0.573556] printk: console [ttyS0] disabled
- [ 0.582069] 10000c00.uartlite: ttyS0 at MMIO 0x10000c00 (irq = 20, base_baud = 2500000) is a Palmchip BK-3103
- [ 0.601712] printk: console [ttyS0] enabled
- [ 0.601712] printk: console [ttyS0] enabled
- [ 0.618276] printk: bootconsole [early0] disabled
- [ 0.618276] printk: bootconsole [early0] disabled
- [ 0.648531] spi spi0.0: force spi mode3
- [ 0.673158] gsw: setting port4 to ephy mode
- [ 0.681726] mtk_soc_eth 10100000.ethernet: generated random MAC address 36:29:df:5d:0b:0f
- [ 0.698051] mtk_soc_eth 10100000.ethernet: no mdio-bus child node found
- [ 0.711245] mtk_soc_eth 10100000.ethernet: mdio-bus disabled
- [ 0.722748] mtk_soc_eth 10100000.ethernet: loaded mt7620 driver
- [ 0.735320] mtk_soc_eth 10100000.ethernet eth0: mediatek frame engine at 0xb0100000, irq 5
- [ 0.752380] rt2880_wdt 10000120.watchdog: Initialized
- [ 0.763791] NET: Registered protocol family 10
- [ 0.778263] Segment Routing with IPv6
- [ 0.785774] NET: Registered protocol family 17
- [ 0.794767] 8021q: 802.1Q VLAN Support v1.8
- [ 0.805353] /dev/root: Can't open blockdev
- [ 0.813599] VFS: Cannot open root device "(null)" or unknown-block(0,0): error -6
- [ 0.828532] Please append a correct "root=" boot option; here are the available partitions:
- [ 0.845184] Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0)
- [ 0.861648] Rebooting in 1 seconds..
Advertisement
Add Comment
Please, Sign In to add comment
Advertisement